TB-3066
Page 4 of 8
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
Desco.com
INSTALLING THE COMBO TESTER X3 AND STAND
1. Insert the pedestal to the baseplate with the
mounting bracket sloping toward the operator. Be
sure to align the screw holes located at the base of
the pedestal.
2. Use the two 1/4-20 socket cap screws to secure the
pedestal to the baseplate.
Figure 4. Securing the pedestal to the baseplate using
the 2 socket cap screws
Figure 5. Routing the ground and foot plate cords
through the pedestal
3. Route the ground and foot plate cords through the
pedestal. Feed the cords from the bottom and have
them exit through the top.
4. Align the backplate’s two holes located above and
below the tester to the two holes on the pedestal’s
mounting bracket. Secure the backplate using the
two included 10-32 pan head screws and nuts.
5. Insert one end of the foot plate cord into the foot
plate jack located at the bottom of the tester.
Connect the other end of the foot plate cord into the
jack located on the dual foot plate.
6. Insert the ground cord’s banana plug into the
ground jack located at the bottom of the tester.
Connect ground cord’s ring terminal to equipment
ground. This connection will remove any static
charge from the user before the test.
NOTE: Failure
to correctly ground the Combo Tester X3 may result
in damage not covered under warranty.
7. Fit the dual foot plate into a position so that it is
flush with the front and top of the baseplate. Secure
the dual foot plate to the baseplate using the four
included #4 pan head screws.
Figure 6. Securing the Combo Tester X3 to the pedestal
