DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
TB-3054
Page 4 of 6
© 2017 DESCO INDUSTRIES, INC.
Employee Owned
Installation
5. The ground cord included with the Multi-Mount
Continuous Monitor may be used to ground the
worksurface mat if it is not already grounded.
Attach the tinned wire end of the included ground
cord to the appropriate terminal block connection on
the right-side of the monitor.
6. Route the ground cord from the monitor to the
worksurface mat. Use either the included push and
clinch snap or washer and screw to secure the cord
to the mat. This snap must be installed 12 to 72
inches away from the snap used for the mat monitor
cord.
7. Connect the power adapter to the power jack
located on the right-side of the monitor. Route the
wire from the supply to a nearby AC outlet and
plug it into the outlet. Make sure the voltage and
frequency match those listed on the power supply.
The monitor is now powered.
NOTE:
Worksurface must have a conductive layer
such as Dual Layer Rubber or Dissipative 3-Layer
Vinyl or Micastat
®
Dissipative Laminate with conductive
buried layers. Desco continuous monitors are not
recommended for use with homogeneous matting.
Figure 6. Screw allows ground cord to be bolted to mat
to keep cord from disconnecting
Worksurface
Snaps must be 12 to 72 inches apart
Figure 5. Installation method #2
Worksurface
Figure 4. Installation method #1
1. Remove the monitor from the carton and inspect for
damage.
2. Determine the mounting location of the Multi-Mount
Continuous Monitor. Its LEDs should be visible to
the operator. Use the included mounting screws or
hook and loop fasteners if desired.
3. Attach the tinned wire end of the mat monitor cord
to its appropriate terminal block connection located
on the right-side of the monitor.
4. Route the mat monitor cord from the monitor to the
worksurface mat. Use either the included push and
clinch snap or washer and screw to secure the cord
to the mat (see Figure 6).
Figure 7. Mounting hole locations on the Multi-Mount
Continuous Monitor (all dimensions are in inches)
3.50
3.87
.188
2.08
.90
