![background image](http://html1.mh-extra.com/html/desa/vm36e/vm36e_owners-operation-and-installation-manual_2486104019.webp)
www.desatech.com
108796-01L
19
TO TURN OFF GAS
TO APPLIANCE
1. Turn off the wall switch.
2. Turn off all electric power to the appliance
if service is to be performed.
3. Fully open glass doors if installed.
4. Remove front hearth brick and control
access panel.
5. Turn gas control knob clockwise
to “OFF”. Do not force.
6. Replace front refractory brick access
panel.
7. Fully close glass doors if installed.
OPTIONAL REMOTE
OPERATION
Note
:
The WRC receiver and hand-held re
-
mote control kit must be purchased separately
(see
Accessories
, page 29). Follow installation
instructions on page 10.
1. Turn equipment shutoff valve to ON posi
-
tion. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT
:
Be sure to press the ON/OFF
buttons on the hand-held remote control
unit for up to 3 seconds to assure proper
operation.
2. Press the ON/OFF button to turn the
burner on and off.
oPeratInG FIrePlaCe
Continued
Figure 38 - Pilot
Sensing
Rod
Pilot
Burner
Ignitor
Pilot
Burner
Ignitor/
Sensor
InsPeCtInG burners
Check pilot flame pattern and burner flame pat-
terns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper
flame. Alterations may have occurred during ship-
ping and handling. The pilot is located on the back
right hand side of the burner.
The flame must envelope 1/4" of top of the ignitor/
sensor and grounding stem.
If your pilot assembly does not meet these re-
quirements:
• Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise to
increase the flame to proper size (see Figure 37,
page 19). Do not remove the adjustment screw.
• see
Troubleshooting
, page 22
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating.
Flames should go up through the middle of logset.
Flames should not "spill" to the edges of the pan
or sides of the logset.
Figure 40 shows a typical flame pattern. If burner
flame pattern differs from that described:
• turn appliance off (see
To Turn Off Gas to Ap-
pliance
)
• see
Troubleshooting
, page 22
Figure 39 - Correct Pilot Flame Pattern
Figure 40 - Typical Flame Pattern
Sensing
Rod