www.desatech.com
108795-01V
15
0.5"
0.5"
Figure 24 - Pan and Ember Material
Clearances
Grate
Burner Pan
Pan and Ember
Material
INstallatIoN
Continued
LOG PLACEMENT FOR M36, M36P,
VM36 AND VM36P MODELS
1. Place small front right log (log 1) on right
front of grate as shown in Figure 25.
2. Place large back log (log 2) onto grate
making sure notches rest over grate as
shown in Figure 25.
3. Place log 3 into notch on log 2, resting
front end on top of log 1 (see Figure 26).
4. Place upper end of log 4 into notch on log
2 as shown in Figure 26. Rest lower end
of log 4 onto middle grate finger as shown
in Figure 27.
5. Place upper end of log 5 into notch on left
of log 2 (see Figure 27). Rest lower end
of log 5 on grate as shown in Figure 28.
6. Insert lower end of log 6 between first
two grate fingers as shown in Figure
28 and position upper end of log 6 into
notched area on front of log 2 as shown
in Figure 28.
As an option to enhance the look of the hearth,
you may place the lava rock provided around
front and sides of burner.
Figure 25 - Installing Logs 1 and 2
Log 1
Log 2
Notch
Figure 26 - Installing Logs 3 and 4
Log 3
Log 4
Log 2
Log 1
Notches
NOTICE: Do not put lava rock in
-
side burner pan or around the air
mixer fitting. Placing lava rock
inside burner pan or blocking
openings of the propane/LP air-
mixer could cause performance
problems.
Figure 27 - Installing Logs 5 and 6
Log 5
Log 6
Log 4
Notch
Notch
Figure 28 - Logs Installed for M36, M36P,
VM36 and VM36P Models
