![background image](http://html1.mh-extra.com/html/desa/victorian-v42en-a-series/victorian-v42en-a-series_owners-operation-and-installation-manual_2486447022.webp)
111907-01D
For more information, visit www.desatech.com
For more information, visit www.desatech.com
22
Figure 38 - Installing Rear Brick Panel
Figure 39 - Installing Left Side and Top Brick Panels
Rear Brick Panel
Left Side
Brick Panel
10. Close glass door and lock latches on top and bottom of door
and replace screen. See Removing/Replacing Glass Door, steps
5 and 6, page 21.
11. Close top and bottom louvers.
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass
door. See Removing/Replacing Glass Door, steps 1 and 2, page 21.
Install logs according to instructions for fireplace model numbers.
1.
Place log #1 (base log) onto pin on left front side of grate as
shown in Figure 40.
Figure 40 - Installing Log No. 1
1
1
INSTALLING OPTIONAL BRICK LINER
MODELS BL42DA(SA), BL42DHA(SA)
WARNING: If fireplace has been running, turn
off and unplug fireplace. Let cool before installing
brick liner.
This brick liner kit is optional. You may purchase brick liner from
your local retailer or see Accessories, page 37.
CAUTION: Always handle brick panels with two
hands. Do not force brick panels into place. Exces-
sive force will break brick panels.
1.
Remove top and bottom louvers to allow access to door latches.
2.
Remove screen, unlock door latches and open glass door. See
Removing/Replacing Glass Door, steps 1 and 2, page 21.
3.
If installing brick liner in new fireplace, go to step 4. If install-
ing brick liner in an existing fireplace, carefully remove logs,
lava rock, and ember material.
4.
Remove three screws from deflector shield on the inside top
of firebox. Set shield and screws aside.
5.
Install rear brick panel first. Rest bottom edge of panel on back
edge of grate (see Figure 38).
6.
Install left side brick panel by sliding it between the grate and
the side of the firebox (see Figure 39).
7.
Install the right brick panel using the same method described
in step 6 for left brick panel.
8.
Replace deflector shield using screws removed in step 4.
9.
Install logs, lava rock and glowing embers. See Installing Logs,
Lava Rock and Glowing Embers, pages 22 and 23.
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL42DA(SA), BL42DHA(SA)