www.desatech.com
113084-01C
16
ON
OFF
REMOTE
O
FF
PILO
T
O
N
L O
I H
OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1
. Follow steps 1 through 6 under
Lighting In-
structions
, page 15.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
through 11 under
Lighting Instructions
,
page 15.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note:
All remote control accessories must be
purchased separately (see
Accessories,
page 27).
Follow instructions included with the remote
control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions
on page 14.
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Ad-
just flame adjustment knob anywhere between
HI and LO. Slide the selector switch to the RE-
MOTE position (see Figure 22).
Note:
The
burner may light if hand-held remote was on
when selector switch was last turned off. You can
now turn the burner on and off with the hand-
held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 23).
TO LOCK
press both buttons on hand-held re-
mote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together on
hand-held remote control until the light stops
flashing. The hand-held remote is now un-
locked.
Figure 22 - Setting the Remote Selector
Switch, Control Knob, and Flame
Adjustment Knob for Remote Operation
Remote Selector Switch in
REMOTE Position
(Optional Remote Control)
Flame Adjustment Knob
Control Knob
in ON Position
THERMOSTAT SERIES (MODEL
GHRCTB)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 24). To select
Fahrenheit/Centigrade mode display, carefully
press the
˚
C/
˚
F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons together
to turn on the hand-held remote control.
2. Press the MANU button to turn on the
heater.
Figure 23 - On/Off Hand-Held Remote
Control Unit (GHRCB)
Control Button
Turns Burners
On and Off
Figure 24 - Thermostat Hand-Held
Remote Control Unit (GHRCTB)
Turns
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects Auto
Setting
Increases
Room
Temperature
in AUTO
Mode
Digital Display
Shows
Temperature
and Settings
Turns Burners
On or Off
Decreases
Room
Temperature
in AUTO Mode
Locks System to
Prevent Accidental
Ignition
