www.desatech.com
124183-01B
11
6. Install gas connector tube to gas supply
fitting. Carefully shape tube to attach to
adapter fitting. Be careful not to cause
kinks in tube.
7. Test for leaks following instructions under
Testing Burner for Leaks
, page 12.
8. Retighten and adjust location of gas control
as necessary. Gas control should be level,
with control rod to front.
9. Install cover to burner pan using screws
provided.
10. Install thermocouple, pilot, and ignitor onto
valve cover as shown in Figure 11. Use
provided screws.
11. Push control rod extension onto “D”
shaped control rod through center hole
in cover.
12. Install position decal and control knob
making sure to align marks with correct
stop positions of gas control. Pilot position
will allow knob to push in about 1/2". Align
decals in pilot position.
INSTALLATION
Continued
Figure 11 - Installing Cover, Control
Knob, and Piezo Ignitor
Piezo Ignitor
Control Rod
Extension
Screw
Valve Cover
Control
Knob
Thermocouple
Ignitor
Pilot
PROPANE/LP GAS CONVERSION
To convert to propane/LP gas, burner inlet
fitting and pilot orifice must be replaced.
Propane/LP burner inlet fitting is supplied
with orifice installed for a 24" log set. If you
have an 18" or 30" set, you must change this
orifice also. See Figure 1, page 5 for product
identification.
Burner Inlet Fitting
1. Remove burner inlet fitting from burner
pan assembly. DO NOT remove orifice
from this fitting. Propane/LP burner inlet
fitting is included in hardware kit (see
Figure 12).
2. Be sure to use correct orifice for your ap
-
pliance. The hardware kit included with
this appliance contains two orifices with
a cone-like shape. If you have an 18" set,
orifice for burner inlet fitting is red; for a 30"
set, it is black. If you have a 24" log set,
orifice is already installed inside fitting.
3. For an 18" or 30" set, use a 10 mm socket or
nut driver to remove orifice from propane/LP
burner inlet fitting. Choose the correct orifice
for your log set size and install in place of
orifice you just removed.
4. Using thread sealant (resistant to the ac
-
tion of propane/LP gas) on larger end of
fitting, screw burner inlet fitting through
hole and into burner manifold (see Figure
13). Tighten using a wrench.
5 . Follow steps 1 through 12 under
Natural
Gas Installation
, page 10.
Figure 12 - Burner Inlet Fittings with
Injectors
Figure 13 - Remove Burner Inlet Fitting
Burner Inlet
Fitting for
Natural Gas
NATURAL
GAS
FITTING
PROPANE/
LP GAS
FITTING
Injector
for Natural
Gas
Injector for
Propane/
LP Gas
