107157-01F
15
15
For more information, visit www.desatech.com
For more information, visit www.desatech.com
MANUAL LIGHTING
PROCEDURE
1.
Follow steps 1 through 5 under Lighting Instructions, page 14.
2.
Depress control knob and light pilot with match.
3.
Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob. Now follow
step 8 under Lighting Instructions, page 14.
Shutting Off Fireplace
Turn control knob clockwise
Clockwise
to the OFF position.
Shutting Off Burners Only (pilot stays lit)
Turn control knob clockwise
Clockwise
to the PILOT position.
THERMOSTAT CONTROL
OPERATION
You can set the thermostat control knob to any comfort level
between HI and LO. The thermostat will gradually modulate the
heat output and flame height from higher to lower settings, or pilot,
in order to maintain the comfort level you select. The ideal comfort
setting will vary by household depending upon the amount of space
to be heated, the output of the central heating system, etc.
Note:
Selecting the HI setting will cause the burner to remain
on without modulating down in most cases.
OPERATING FIREPLACE
Continued
TO TURN OFF GAS
TO APPLIANCE
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
FOR YOUR SAFETY
READ BEFORE LIGHTING
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don’t try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
1.
STOP! Read the safety information starting in column 1.
2.
Make sure equipment shutoff valve is fully open.
3.
Turn control knob clockwise
Clockwise
to the OFF position.
(see Figure 29, page 16)
4.
Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP! Fol-
low “B” in the safety information starting in column 1. If
you don’t smell gas, go to the next step.
5.
Slightly depress and turn control knob counterclockwise
C-clockwise
to the PILOT position. Press in control knob for
five (5) seconds (see Figure 29, page 16).
Note:
If running fireplace for first time, there will be air in
gas line. You may need to press in control knob for 30 seconds
or more. This will allow air to bleed from the gas system.
6.
Continue pressing control knob in. Press and release igni-
tor button. This will light pilot. The pilot is attached to the
front burner. If needed, keep pressing ignitor button until
pilot lights.
Note:
If pilot does not stay lit, contact a qualified service
person or gas supplier for repairs. Until repairs are made,
light pilot with match. To light pilot with match, see Manual
Lighting Procedure, page 16.
LIGHTING INSTRUCTIONS
WARNING: You must operate this fireplace with
the fireplace screen in place. Make sure fireplace
screen is installed before running fireplace.
NOTICE: During initial operation of new fireplace, burn-
ing logs will give off a paper-burning smell. Open damper
or window to vent smell. This will only last a few hours.
OPERATING FIREPLACE (T-STAT MODELS)
To Turn Off Gas To Appliance
Thermostat Control Operation
Manual Lighting Procedure
OPERATING FIREPLACE (MANUALLY CONTROLLED MODELS)
For Your Safety Read Before Lighting
Lighting Instructions
MANUALLY-CONTROLLED MODELS
