12
107050
VENTED TYPE DECORATIVE APPLIANCE
EVGL850N
®
TO TURN OFF GAS
TO APPLIANCE
1.
Turn off the wall switch.
2.
Turn off all electric power to the ap-
pliance if service is to be performed.
3.
Remove the glass door.
4.
Open control access panel.
5.
Turn equipment shutoff valve clock-
wise
Clockwise
to “OFF”. Do not force.
6.
Close control access panel.
7.
Replace the glass door.
Figure 28 - Pilot
OPTIONAL REMOTE
OPERATION
Note:
The WRC receiver and hand-held
remote control kit must be purchased sepa-
rately (see Accessories, page 17). Follow
installation instructions on page 8.
1.
Turn equipment shutoff valve to ON
position. You can now turn the
burner on and off with the hand-held
remote control unit.
IMPORTANT:
Be sure to press the
ON/OFF buttons on the hand-held
remote control unit for up to 3 sec-
onds to assure proper operation.
2.
Press the ON/OFF button to turn the
burner on and off.
OPERATING
FIREPLACE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
A. This appliance is equipped with an
ignition device which automatically
lights the pilot. Do not try to light the
pilot by hand.
B. BEFORE LIGHTING smell all
around the appliance area for gas. Be
sure to smell next to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL
GAS
• Do not try to light any appliance.
• Do not touch any electric switch.
• Do not use any phone in your
building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow
the gas supplier’s instructions.
• If you cannot reach your gas sup-
plier, call the fire department.
C. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been un-
der water.
LIGHTING
INSTRUCTIONS
1.
STOP! Read the safety information,
column 1.
2.
Turn off all electric power to the
appliance.
3.
Turn wall switch to the OFF position.
4.
Remove the glass door.
5.
Open control access panel.
6.
Turn the equipment shutoff valve
clockwise
Clockwise
to the OFF posi-
tion (see Figure 27). Do not force.
7.
Wait five (5) minutes to clear out any
gas. Then smell for gas, including
near the floor. If you smell gas, STOP!
Follow “B” in the safety information,
column 1. If you don’t smell gas, go to
the next step.
8.
Turn the equipment shutoff valve
counterclockwise
C-clockwise
to the ON
position. Do not force.
9.
Close control access panel.
10. Replace the glass door.
11. Turn on all electric power to the ap-
pliance.
12. Turn the wall switch to the ON posi-
tion.
13. Visually locate the pilot. The ignitor
should begin to spark and the main
burner should ignite once flame ap-
pears at pilot.
• If lighting the appliance for the
first time each season, it may take
several attempts before the supply
gas can reach the pilot and main
burners.
• If the appliance will not stay lit af-
ter several attempts, follow the in-
structions To Turn Off Gas To Ap-
pliance, column 3, and call your
service technician or gas supplier.
Figure 27 - Turning the Equipment Shutoff
Valve to the OFF position
Equipment Shutoff Valve
Control Valve
Pilot
Assembly
Ignitor/Sensor
