3
105815
INSTALLATION INSTRUCTIONS
9.
Replace pilot target removed in step 6,
page 2. Tighten pilot target hex fitting
until the pilot target aligns with the ther-
mocouple and thermopile (see Figure 8).
10. Replace original burner with burner
supplied with conversion kit. Attach
with the two 5/16" hex mounting
screws removed in step 5, page 2.
11. Attach main burner orifice and brass
elbow assembly to burner. Place main
burner orifice into threaded end of
burner and turn clockwise to tighten
(see Figure 4, page 2). Align the brass
elbow with the flare fitting on the alu-
minum tubing.
12. Reconnect the aluminum tube/flare fit-
ting onto the brass elbow (see Figure 4,
page 2).
13. Reapply RTV silicone to seal area where
orifice passes through the bottom com-
bustion chamber (see Figure 4, page 2).
Continued
Thermocouple
Thermopile
Pilot Target
Figure 8 - Pilot Target Alignment
GAS CONTROL VALVE
CONVERSION
Convert the gas control valve by swapping
out the valve regulator portion of the gas
valve.
1.
Open bottom swing door on stove to
allow access to gas control valve.
2.
Using a phillips head screwdriver, re-
move the two mounting screws fasten-
ing the regulator assembly to the gas
control valve (see Figure 9).
3.
Remove regulator assembly and rubber
gasket from control valve (see Figure 9).
LO
H
I
P
I
L
O
T
OFF
ON
Machine Screws
(Phillips Head)
Regulator Assembly
Rubber
Gasket
Gas Control
Valve
Figure 9 - Removing/Replacing Regulator
Assembly and Rubber Gasket
4.
Place rubber gasket supplied with regu-
lator kit on gas control valve. Align two
of the holes on the gasket with orienta-
tion pins on gas control valve.
IMPORTANT:
Make sure gasket is
properly seated and aligned on gas con-
trol valve.
5.
Position regulator assembly supplied
with conversion kit over rubber gasket
on gas control valve. Align the notch
in the regulator assembly with the pin
on the gas control valve.
6.
Attach regulator assembly to gas con-
trol valve using the two mounting
screws removed in step 2, page 2.
Tighten screws securely (approxi-
mately 25in-lbs.) (see Figure 9).
CONVERSION LABELING
AND PLACEMENT
1.
Apply the English and French conver-
sion labels over the top of the existing
certification labels (see Figure 10). Ex-
isting certification labels are located on
the lighting instruction plate inside the
gas valve compartment area. With per-
manent ink, print the previous model
number on the label in the space pro-
vided (see Figure 11).
2.
After filling in the data required on the
conversion information label, affix it to
the stove bottom next to the gas con-
trol valve. Make sure it is easily seen
when the swing door is opened (see Fig-
ure 12).
English This
Side
French This
Side
Figure 10 - Applying English and French
Conversion Labels over Existing
Certification Labels on Lighting
Instruction Plate
DIRECT VENT DECORATIVE FIREPLACE
Conversion Kit Model
Type of Gas
®
Previous Model #
Figure 11 - Print Previous Model Number
on Conversion Labels
CONVERSION INFORMATION LABEL
This appliance was converted on
(name and address of organization making
this conversion), which accepts the
responsibility that this conversion has been
properly made.
Day
Month
Year
–
–
to
gas
with Kit No.
by
106080-01
56060
Figure 12 - Conversion Information Label
Lighting Instruction
Plate
