www.desatech.com
113084-01J
11
INSTALLATION
Continued
cAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
INSTALLING GAS LOG INTO STOVE
1. Remove log from carton.
2. Remove all protective packaging applied
to log for shipment.
3. Check log for any shipping damage. If
damaged (pieces larger than the size of a
dime), promptly inform dealer where you
bought heater.
4. Set one-piece log on heater base as
shown in Figure 12. Make sure middle
section at bottom of log is seated into “U”
shaped cutout in center of heater base.
Log will fit securely on base.
IMPORTANT:
Make sure log does not cover any burner
ports and does not touch the stove cavity
(see Figure 13).
5. Fasten back panel to stove with four M6
x 1 bolts and washers.
6. Place freestanding stove in desired posi-
tion in room. Be sure to maintain clear-
ances to combustibles as outlined on
page 8.
cAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact
-
ing logs will create soot.
Burner Porting Areas (double
slotted rectangular openings)
Figure 13 - Top View of One-Piece Log
Set on Gas Log Heater
Safety Pilot Location
One-Piece
Log Set
One-Piece
Log Set
“U” Shaped
Cutout in Chassis
Burner
Middle
Section at
Bottom of
Log Set
Figure 12 - Installing One-Piece Stove
Log Set
Heater Base
cONNEcTING TO GAS SUPPLY
WARNING: This appliance
requires a 1/2" NPT (National
Pipe Thread) inlet connection to
the pressure regulator.
WARNING: A qualified service
person must connect heater to gas
supply. Follow all local codes.
cAUTION: Never connect
propane/LP heater directly to the
propane/LP supply. This heater
requires an external regulator
(not supplied). Install the exter
-
nal regulator between the heater
and propane/LP supply.
