108122-01D
For more information, visit www.desatech.com
For more information, visit www.desatech.com
4
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
Technical Service and Parts:
1-866-672-6040
108122-01
Rev. D
10/03
108122 01
NOT A UPC
ASSEMBLING AND INSTALLING BRASS TRIM
1.
Remove packaging from three pieces of brass trim.
2.
Locate 2 adjusting plates with set screws and 2 shims in the
hardware packet.
3.
Align shim under adjusting plate as shown in Figure 8.
4.
Slide one end of adjusting plate/shim in slot on mitered edge
of top brass trim (see Figure 8).
5.
Slide other end of adjusting plate/shim in slot on mitered edge
of side brass trim (see Figure 8).
6.
While firmly holding edges of brass trim together, tighten both
screws on the adjusting plate using a slotted screwdriver.
Figure 8 - Assembling Brass Trim
Figure 9 - Assembling Brass Trim
ASSEMBLING MANTEL
Continued
Side Brass Trim
Mitered Edge
Shim
Adjusting Plate
Set Screws
Top Brass Trim
Slot
Slot
7.
Repeat steps 1 through 6 for other side.
8.
Locate seven hanging shoulder screws in hardware packet.
Tighten the seven hanging shoulder screws (#10-16x.50 long
with .12 shoulder) into holes on firebox sides. Place the
assembled trim onto firebox cabinet. Align hanging notches
on trim with hanging screws on side of firebox (see Figure 9).
Tap trim firmly into place with palm of hand engaging hanging
notches around shoulder screws. Start at one end of the trim
and work around firebox until all notches are fully engaged.
Assembled
Brass Trim
Trim Hanging
Shoulder
Screws
Hanging Notches
on Trim
Shoulder Screw
Hanging
Notches
on Trim
