www.desatech.com
110399-01J
18
INSTALLATION
Continued
Figure 22 - Installing Vintage Oak Log
Sets (Top View)
Log Set
Burner Ports
Figure 25 - Installing Golden Oak Log
Sets (Top View)
Figure 24 - Installing Golden Oak One-
Piece Log Set
Middle
Section at
Bottom of
Log Set
One-Piece
Log Set
Chassis
Burner
“U”-shaped
Cutout in Chassis
Log Set
Burner Ports
Vintage Oak and Golden Oak One-Piece
Log Set
1. Place one-piece log set on grate to fit as
illustrated in Figure 23 for Vintage Oak
models and Figure 24 for Golden Oak
models. For Vintage Oak models make
sure bottom of front log is in front of “U”-
shaped cutout in center of chassis (see
Figure 23). For Golden Oak models make
sure middle section at bottom of log set
is seated into “U”-shaped cutout in center
of chassis (see Figure 24).
IMPORTANT:
Make sure log does not cover any burner
ports (see Figure 22 or 25).
2. Place lava rock around base of heater if
desired.
Figure 23 - Installing Vintage Oak One-
Piece Log Set
One-Piece
Log Set
Chassis
Burner
“U”-shaped
Cutout in
Chassis
Golden Oak Five-Piece Log Set
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
1. Place front log (#1) on top of the grate
(see Figure 26, page 19). Log will fit down
between grate and front of chassis.
2. Rest middle log (#2) inside “U”-shaped cut-
outs in chassis (see Figure 27, page 19).
