![background image](http://html1.mh-extra.com/html/desa/ez18nr/ez18nr_owners-manual_2485860017.webp)
www.desatech.com
114668-01F
17
INSTALLATION
Continued
Figure 20 - Installing Remote Receiver
Push
Button
Clips
Bracket
Battery
Clip
9-Volt Battery
Terminal
Wires
Pad
Figure 19 - Disconnecting Jumper Wire
From Control Valve
Jumper
Wire
Control Valve
Figure 18 - Installing Remote Receiver
Bracket
Remote Receiver Bracket
Phillips
Screws
Figure 21 - Connecting Wires
Control Valve
White
Wire From
Receiver
Red Wire
From Receiver
6. Install receiver bracket to base with phil
-
lips screws provided in hardware kit as
shown in Figure 18.
7. Disconnect jumper wire from control valve at
TPTH and TH locations (see Figure 19).
8. Install remote receiver into receiver
bracket using pads and push button clips
provided with receiver (see Figure 20).
9. Connect wires to control valve at the
TPTH and TH locations as shown in
Figure 21.
Note: Make sure excess wire
does not interfere with burner or pilot.
10. If heater was removed from fireplace be
-
fore installation of remote accessory, see
Installing Heater Base Assembly
, page 13
to reinstall heater into fireplace. Test gas
connection for leaks (see
Checking Gas
Connections
, page 15).
11. If logs were removed from heater for in
-
stall remote accessory, replace logs (see
Installing Logs
, page 18).
INSTALLING BATTERIES FOR REMOTE
RECEIVER AND HAND HELD REMOTE
CONTROL
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand-held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver behind receiver
bracket mounted on base assembly.
2. Locate the battery clip mounted on the
back of the receiver (see Figure 20).
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control
unit.
Battery
Cover
9-Volt
Battery
Terminal
Wires
Battery
Housing
Remote
Control
Unit
Figure 22 - Installing Battery in Hand-Held
Remote Control Unit