www.desatech.com
113146-01B
3
ASSEMBLING TRIM
1. Remove packaging from three pieces of trim.
2. Locate two adjusting plates with set screws, and two shims in
the hardware packet.
3. Align shim under adjusting plate as shown in Figure 7.
4. Slide one end of adjusting plate/shim in slot on mitered edge
of top trim (see Figure 7).
5. Slide other end of adjusting plate/shim in slot on mitered edge
of side trim (see Figure 7).
6. While firmly holding edges of trim together, tighten both set
screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 2 through 6 for other corner.
INSTALLING FIREPLACE WITH FULL
HEARTH BASE
1. Fireplace should be fully assembled. See
Assembling Fireplace
in fireplace ownerʼs manual,
2. Place mantel base next to wall at installation location. See
fireplace ownerʼs manual for installation clearances.
3. Place fireplace on wood mantel base and center left to right.
Turn mantel right side up, then slide mantel assembly over
heater (see Figure 8).
4. Firmly snap trim assembly on shoulder screws. Shoulder screws
are located on fireplace cabinet (see Figure 8). (Locations may
vary with fireplaces.)
5. Align fireplace, base, and mantel so that the trim overlaps the
mantel evenly on all three sides.
6. Lower bottom louver door. Use two 3" wood screws provided
in hardware packet and attach fireplace base to wooden base
(see Figure 9, page 4).
7. Make sure rear of legs are flush with back of top, and mantel is
centered left to right inside top. Square legs evenly with sides
of mantel top, making certain gap between mantel top and
leg is the same from front to back. See Figure 6. Attach both
brackets to mantel top with #8 x 3/4" particle board screws.
Figure 7 - Assembling Trim
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
Figure 6 - Securing Top to Leg and Header Assembly
Metal
Brackets
Legs Should Be
Flush With Top
#8 x 3/4"
Particle Board
Screws
Small
Gap
O
F
F
P
ILO
T
O
N
H
I
L
O
Figure 8 - Fireplace, Trim Assembly, Mantel, and Mantel Base
Shoulder Screw
Assembled
Trim
Hole for 3" Wood Screw for Attaching
Fireplace to Wooden Base
Shoulder
Screws
Gas Line Ac-
cess Hole
Mantel Base
(Side view
for clarity)
Make certain
spacing is the
same front
and back.