www.desatech.com
119719-01A
5
FRAMING
Figure 3 shows a typical framing of this heater us-
ing combustible materials. All required clearances
to combustibles must be adhered to. Header height
is measured from the base of the heater.
Tools and building supplies required for
installation:
• Saw
• Square
• Pliers
• Gloves
• Hammer
• Level
• Phillips screwdriver
• Framing materials
• Tape measure
• Surround
• Wall-finishing materials • Caulking material
• Electric drill/bits
LOCATING FIREPLACE
Continued
CAUTION: Provide adequate
clearances around the air open-
ings and adequate accessibility
clearances for servicing and
proper operations.
Figure 3 - Framing Heater for New
Construction/Renovation
3
1
/
"
Header
Height
3/4" - 1/"
19
1
/
"
9
3
/
4
"
Note:
The height that a combustible mantel is
fitted above the heater is dependent on the height
of the front selected. The minimum height is 1"
above the front.
INSTALLATION
WARNING - RISK OF FIRE!
The power cord must not be
pinched or against a sharp edge.
Secure cord to avoid tripping or
snagging to reduce the risk of fire,
electric shock or personal injury.
Do not run cord under carpeting.
Do not cover cord with throw
rugs, runners or similar items.
Arrange cord away from traffic
areas and where it will not be
tripped over.
WARNING - RISK OF FIRE!
To prevent a possible fire, do
not block air intake or exhaust in
any manner. Do not use on soft
surfaces (like a bed) where open-
ings may become blocked.
WARNING - RISK OF FIRE!
Do not blow or place insulation
against the firebox.
WARNING: This heater is
tested and listed for use only
with the approved optional ac-
cessories. Use of optional ac-
cessories not specifically tested
for this heater could void the
heater warranty and/or result in
a safety hazard.
