![background image](http://html1.mh-extra.com/html/desa/cdv37n-p/cdv37n-p_owners-operation-and-installation-manual_2486273022.webp)
22
105541
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
CDV37N/P(A,B) AND CDV41N/P(A,B)
INSTALLING OPTIONAL
BRICK LINER CD8037A/
CD8041
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before
installing brick liner.
This brick liner kit is optional. You may
purchase brick liner from your local retailer
or see Accessories, page 31.
CAUTION: Always handle
brick panels with two hands. Do
not force brick panels into place.
Excessive force will break brick
panels.
1.
Remove glass door. See Removing/Re-
placing Glass Door, pages 21.
2.
If installing brick liner in new fireplace,
go to step 3. If installing brick liner in
an existing fireplace, carefully remove
logs, lava rock, and ember material.
3.
Install left side brick panel first by slid-
ing it between the grate and the side of
the firebox (see Figure 44).
4.
Slide the left retainer bracket against
the left side brick panel. Loosely se-
cure the bracket screw. This secures the
left side brick panel.
5.
Install the right brick panel using the
same method described in step 3.
6.
Slide the right retainer bracket against
the right side brick panel. Loosely se-
cure the bracket screw. This secures the
right side brick panel.
7.
Install rear brick panel. Rest bottom
edge of panel on back edge of grate (see
Figure 45).
Figure 44 - Installing Left Side Brick Panel
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing or
broken.
FIREPLACE
INSTALLATION
Continued
Figure 45- Installing Rear Brick Panel and Retainer Brackets
Left Side
Brick Panel
Retainer
Brackets
Rear Brick Panel
Retaining Brackets
Attaching Magnetic Decorative
Brass Strips
This fireplace comes with a set of two
magnetic decorative brass strips. Before
attaching strips to fireplace, remove plastic
film from brass pieces. After installing the
door, attach these strips to the top and bot-
tom of the glass door frame.
8.
Loosely secure retainer brackets to grate.
Brackets are adjustable left to right to
allow proper placement of panel. These
will hold rear panel in place.
9.
Tighten all bracket screws.
10. Follow instructions on page 23 to install
logs, lava rock, and ember material.
11. Replace glass door (see page 21).