www.desatech.com
112471-01B
17
INSTALLING LOGS
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
Note:
Your appliance may vary from model
shown but log placement will be the same.
1. Slide the grooves in the back of the rear log (#1)
against the rear grate prongs. See Figure 21.
2. Rest center log (#2) behind metal posts on front
burner. Make sure the grooves in the bottom of
the log fit over the grate. Bring the log forward
next to the metal posts. The pegs in the middle
log must be on top (see Figure 22).
3. Place front log (#3) on top of the grate. Make
sure the notches in the bottom of the log fit
over the grate prongs (see Figure 23).
4. Place the top left log (#4) and left crossover
log (#5) on the center log and the back log as
shown in Figure 24. (The left crossover log is
for 30" log sets only.) Make sure the pegs on
the center log are in the holes in the bottom
of the top and crossover logs.
INSTALLATION
Continued
Rear Log (#1)
Metal Post
Groove
(On Back
of Log)
Groove (On
Back of Log)
Grate
Prong
Figure 22 - Installing Center Log (#2)
(30" Remote Ready Set Shown)
Center
Log (#2)
Peg
Figure 21 - Installing Rear Log (#1)
(30" Remote Ready Set Shown)
Metal
Post
Grate
Front Log (#3)
Grate Prong
Grate
Prong
Figure 23 - Installing Front Log (#3)
(30" Remote Ready Set Shown)
Figure 24 - Installing Top Left Log (#4)
and Left Crossover Log (#5, 30" Set
Only) (30" Remote Ready Set Shown)
Left Crossover
Log (#5, 30"
Set Only)
Peg
Top Left
Log (#4)
