Aesthetic Technology Limited
18
19
PL-027 (Rev 7)
PL-027 (Rev 7)
• Do not place the system in a dusty or dirty environment.
• The system should be kept away from high temperature sources including direct
sunlight.
• When storing the system, place the LED Array in a flat position.
• The system may be cleaned by following the cleaning instructions in Section 20 of
this User Guide.
• Do not use any other cleaning products other than those stated in this User Guide.
Use of other cleaning products may damage the system.
• When not in use, it is advised to keep the system switched off.
• Avoid contact with children and animals.
WARNING!
CAUTION!
Protective eyewear should be worn by the user when the device is in use.
Do not stare at operating LED Array. May be harmful to the eyes!
Take note of the Warning label found on the inside of the Flex MD,
example listed below.
WARNING!
Inspect the system for any visual damage that may have been caused during transit.
Check warranty labels are intact at time of receiving the device.
If any of the individual components are missing or damaged listed in Section 5 of this
document, please contact Aesthetic Technology Ltd or your local Dermalux® representative
within 24 hours of receiving the system.
Refer to Section 19 for a step by step assembly guide.
For reference the Dermalux® Flex MD system consists of:
• Flex MD Base Unit
• Flexible LED Array
• Flex MD Controller
• RJ11 Cable (2m)
• Power Supply (with 1.5m lead)
• Patient Goggles
• Pillow
• Travel Carry Bag
• User Guide
• Protocol Chart
Figure 3: Flex MD Components.
