Derbi Rambla 250, Manual, Page: 69 / 259

Clock adjustment
•
Press and hold the MODE «2» button longer than three seconds. The colon dividing hours-
minutes starts flashing.
•
Each time the MODE «2» button is pressed, the hour value is increased for adjustment.
•
Pressing the MODE «2» button again longer than three seconds activates the minutes ad-
justment. The value displayed increases each time the MODE «2» button is pressed.
Press the MODE «
2
» button longer than three seconds to go back to the hour adjustment. If no button
is pressed within three seconds, the display automatically exits the clock adjustment function.
NOTE
FOR SAFETY REASONS, ADJUST THE CLOCK ONLY WHEN YOUR VEHICLE IS STOPPED.
Data check function
SERVICE
When the vehicle is started and right after the ignition check, if there are less than 300 km (200 mi) left
to the next Service, the specific icon flashes for 5 seconds. Once the service mileage has been reached,
the icon remains steadily until the Service is reset.
The warning light can be zero set even if the mileage is lower, up to 300 km (200 mi), compared with
the Service mileage. During the 300 km (200 mi) before the service warning light comes on, the light
flashes 5 times each time the key is set to ''ON''.
The light should turn on first at 1000 km (625 mi). Successive times are strictly at 10000 km (6215 mi),
20000 km (12430 mi), etc.
RESET
Hold the MODE button down.
Turn the key to ''
ON
'' and wait 10 seconds.
During this operation the service icon flashes at a
1 Hz frequency.
Electrical system
ELE SYS - 69