Page 37 of 45
-
Disconnect the suction pipe from the suction cap by loosening the strap
-
Remove the cap
-
Remove the H filter and/or the C.C.A cleaning system (if provided)
-
Slip out the filter and place all components on a work bench
-
Loosen the fastening clip (H), remove the filter from its support and, using scissors, cut the
lower belts that clamp it to the shaking cage
Remove the filter, put it in a plastic bag, seal it and dispose it of according to the
current legislation on the type of material extracted
To reassemble the filter
, operate in reverse order:
-
Insert the new filter in the support ring and lock it by means of the fastening clip (H)
-
lock the filter to the cage by tying the special laces on the bottom side
-
insert the filter with ring and cage inside the filtering chamber, paying particular attention to
align the cage to the filter shaking lever
-
insert the lever end into the appropriate seat on the bottom of the cage and then insert the
fastening clip
-
place the H filter and/or the C.C.A cleaning system (if envisaged) on the filter top
-
position the vacuum cleaner cup, insert the suction tube to the cap and tighten the fastening
clip. Then lock the cap with the appropriate locking hooks
-
Connect the C.C.A. cleaning system to the compressed air supply and to the power supply (by
connecting the related connector)
-
lock the dirt container under the filter chamber
-
connect the vacuum cleaner to the mains
-
turn on the vacuum cleaner, immediately assessing its efficient operation.