4.2
Operating cycle
Ensure that the compressed air supply pipe is fitted correctly onto the machine's inlet valve.
Ensure that the hose is inserted properly and locked into the suction inlet.
Ensure that the refuse collection container is properly locked to the vacuum.
Block the vacuum using the lever on the swivel caster, as shown in the figure.
Hold the end of the hose with the chosen accessory.
On one side, attach the pneumatic suction pipe to the FR unit installed on the vacuum, and, on the other side,
to the pneumatic supply valve located upstream of the vacuum.
Open the air supply valve and make sure that the pressure gauge on the FR unit marks an intake pressure between
7÷9 bar.
Start vacuuming.
To turn the vacuum off, close the pneumatic supply valve upstream of the vacuum.
Attention!
Never, for any reason whatsoever, disconnect the pneumatic supply pipe from the vacuum
without firstly closing the pneumatic supply valve upstream of the vacuum.
Do not shift the vacuum while it is operating.
Hold the end of the hose with the chosen accessory.
To move the vacuum use the special grip on the rear part.
Warning!
During operation, prevent the hose from rolling up or bending.
