Setting the unit for precipitation
1.
Press the mode button 5 times, then press the set button for 3 seconds.
2.
Use the up and down arrows to set mm or inches as units
3.
Press the set button to quit settings
Setting the unit for wind speed.
1.
Press the mode button 6 times, then press the set button for 3 seconds.
2.
Use the up and down arrows to set km/h or mph as units.
3.
Press the set button to quit settings
Temperatur alert
The weather staiton can alart you of temperature changes indoors and outdoors. To change alart settings,
press the mode button on the dispay 4 times, then hold the set button for 3 seconds You change the settings
with the set button in the following order: outdoor low temp> outdoor low alarm on/off> outdoor temp high>
outdoor high alarm on /off> indoor low temp> indoor low alarm on /off > indoor high temp>
Indoor temp alarm on/off . Change the values with the up/down buttons.
Temperature, humidity und pressure trends
Moon phases
1.
New moon
2.
Waxing crescent
3.
First quarter
4.
Waxing gibbous
5.
Full moon
6.
Waning gibbous
7.
Last quarter
8.
Waning crescent
Note: In the period between 18:00 and 06:00 , the moon icon will be surrounded by stars
Min./Max.-Temperature memory
The base station saves the min/mas temperature and humidity setting s for each day and deletes the values at
midngith, Prdss the up button once to display the maximum values and press it again the dispay the
minimum values .A third press takes you back to the standard dispay.
Displaying and deleting measured values from the rain gauge sensor
Pressing the down button repeatedly shows measured precipitation values in various time periods in the
following steps:
Accumulated
Rising
Constant
Falling
