Denver HSA-120, Installation And User Manual, Page: 9 / 28

16 17
Enter into Setup mode, type “*9*new password*“.
You hear “Operation succeeded”: the setup is successful.
Note
The password must consist of 4 digits (0 to 9).
Default password: 1234.
4.4 Store Phone Numbers
Example: store the 1st phone number as 12345678.
Enter into Setup mode, type #1#12345678#
You hear “Operation succeeded”: the setup is successful.
Example 2: store the 2nd phone number as 23456789.
Enter into Setup mode, input #2#23456789#
You hear “Operation succeeded”: the setup is successful.
Up to 10 phone numbers can be stored.
Note
The 1st to the 5th stored phone numbers are for calls from the alarm system.
The 6th to the 10th phone numbers are for SMS alert messages.
You hear “Operation succeeded”: the setup is successful.
4.5 Delete Phone Numbers
Example: delete the 1st phone number.
Enter into Setup mode, type “#1##“
You hear “Operation succeeded”: the setup is successful.
Example: delete the 2nd phone number.
Enter setup mode, type “#2##“
You hear “Operation succeeded”: the setup is successful.
Note
Delete all existing phone numbers: “#*##“
4.6 Exit Setup Mode
Press the Disarm key on the control panel to exit the Setup mode until you hear 2 beeps and the setup
LED indicator blacks out: the system has exited the Setup mode
4.7 Alarm Response When Being Out of Home
I
f the system detects an intrusion, the siren will ring out immediately, and the control panel will send
alert SMS and dial the pre-stored phone numbers. The user can monitor the site from distance and
control the system by phone when receiving the call from the alarm system.
Note
No need to type password to control the system from distance when receiving the call from the alarm
system.
4.8 Control by Phone Call
Method 1
When an alarm has been triggered, the control panel dials the pre-stored phone numbers. When you
take the call, you can control the panel from distance according to the instructions in the table below.
Method 2
1. Dial the telephone number of the SIM card in your control panel.
2. Enter your password followed by ”#”.
3. Select the operations to control the panel (see instructions in the table below).
Note
The call will end automatically if you do not send any command within 30 seconds.
*Default password is 1234.
Table of commands for control by phone call
Command Function Comment
Press “1“ Arms the system -
Press “0“
- Disarms the system and turns the siren off
- Stops monitoring without hanging up
- Ends the phone call without hanging up
-
Press “ “ Audio monitoring -
Press “3“ Phone call with control panel -
Press “6“ Turns the siren off -
Press “9“ Turns the siren on -
Press “#“ Exits control by phone call
Hanging up also exits the
control by phone call.
4.9 Siren Volume
1. Set high siren volume: enter into Setup mode, and type “*23*1*“
2. Mute the siren: enter into Setup mode, and type “*23*0*“