5. Operation Instructions
1. Connect the power adaptor (DC12V) to the unit.
2. Switch on the main Power switch on the front panel of the unit and the red light on in standby mode; then pres s
the Power switch again and the green light on in working status.
3. Select AV/TV to receive AV/TV signal.
4. Press CH+ or CH- knob to select the desired TV channel; Keep pressing V+ and V- konb to set the
sound to a suitable level.
5. Select Menu for Auto Scan and storage the TV channels; Press CH+, CH- knob and V+, V- knob in
the Menu to adjust the brightness, contrast, colour and other functions.
6. According to the specified system, default TV system in PAL/ NTSC/ SECAM and set the suitable
Audio system : M, B/G, D/K, I.
7. To receive clearer pi ctures
Adjus t the length, angle and direction of the built-in TV rod antenna (11 ) to get an excellent picture.
VHF-L
1
6. Reset TV Channel:
1. Full automatic channel selection and memory. Press AUTO switch (11)on the R emote Control
for
channel memorized Auto Scan VHF-L,VHF-H,UHF in order.
TV
2. General Parts
1). TV Unit
FRONT VIEW
10
11. Rotary Telescopic
Antenna
12. Stand Holder
3
BACK VIE W
If signal is too weak, you may not get the reception and receive unclear picture, noisy
sound , twisted picture etc., even have just adjusted the rod antenna. In this case, you
should plug the external antenna adaptor into the antenna jack(13) or relocate the TV set
to the place where reception is better.
2
3
4
5
6
7
8
10
1
9
1.
Remote Control Sensor
3.
4.
5.
6.Volume- Control
7. control
8.
9.
10.Built-in Speaker
Channel Down Button.
Channel Up Button
Menu Button
Power On/Standby Indicator
Power On/OFF Button
2.AV/TV Switch