Entry / Exit Delay
A delay before activation can be set for the siren if the sensor is assigned
to the Delay Zone*.
If the Entry / Exit Delay is activated, the siren beeps once every second
until the system is armed, during the period of delay set. If one of your
system’s sensors triggers the alarm, the ringing out of the siren will be
delayed accordingly.
* The name of the Delay Zone and the connection process may vary
depending on models. Refer to the user manual of your alarm system for
more information.
Set up the delay:
Enter Setup Mode by pressing the power button once. Press the power
button again
- once to set the delay to 10 seconds
- twice to set the delay to 20 seconds
- three times to set the delay to 30 seconds
- four times to deactivate the delay
Default setting: no delay.
The delay will be effective only if the sensors
have been assigned to the Delay Zone. To
assign a sensor to the Delay Zone, open its
cover and move the jumpers on the circuit
board according to the opposite drawing.
For more information, refer to the manual of
your alarm system.
Night Lamp mode
When used as a standalone alarm system, the ASA-30 can also be used
as an LED night lamp.
Press the “Stay” button on the remote control twice: the siren switches to
Home Mode and the strobe light turns into a night lamp. Press the “Stay”
button twice, then the “Arm” button once: the siren is in monitoring mode
with night lamp on. Press the “Disarm” button: the siren is disarmed and
the LED lights switch off.