Power on / off
Power on
The siren is powered off as per default settings. Plug the siren to a
220V socket and press the Power button on the siren. You hear a long
beep: the siren is on. You can also turn the siren on by long pressing (6
seconds) the Power button on the siren.
Enter Setup Mode / Power off
Enter Setup Mode by pressing the Power button once. Press again the Power
button for 6 seconds to turn the siren off.
Siren and light indications
When arming the system
The siren beeps once, the LED lights blink once and switch on.
When disarming the system
The siren beeps twice, the LED lights blink twice and turn off.
When armed / disarmed in Mute Mode from the control panel
The siren does not beep, the LED lights do not blink.
Use as an additional siren
If the siren is used as an additional siren, it must be registered to your alarm’s
control panel. If the alarm is triggered, the ASA-30 will ring out and its LED
lights will turn on.
Register the ASA-30 in the control panel
Press the Connect button on the siren. The siren beeps once and the
LEDs light up: the siren is now in Connection Mode.
Press the “SOS” or “Arm” button on the control panel of your alarm
system. You hear one beep: the siren has been registered in the control
panel successfully (if you hear 3 beeps, the siren has already been
connected). Press the Connect button again on the siren to exit the
Connection Mode.
Note
Do not trigger an alarm with a sensor when registering the siren in the
control panel.
Test
Press the “Arm” button on the remote control. Both the built-in siren of
the control panel and the ASA-30 beep: the connection is successful. If
not, the connection has failed, try registering the siren again.