alarm will go on at the radio station you last listened to.
Wake to CD
Press the SKIP+ / SKIP- button until the CD icon is shown in the display(above the time). This feature
only works when you have a CD inserted in the CD drive. This CD will be played at the set alarm time.
1. Press the AL. SET button again to confirm your settings for Alarm 1.
2. The alarm icon (Alarm 2) appears and the HOUR time is blinking.
3. Repeat step 2-6 in order to set Alarm 2.
To select which of the 2 alarms should be active, press the ALARM SET button repeatedly while the unit
is in standby mode (clock display). The display will show consecutively the Alarm 1 icon, the Alarm 2
icon, the both Alarm icons. Press the ALARM SET button once again to deactivate the alarms (no alarm
icon will be displayed).
Turning Off the Alarm:
To switch off an alarm while active, press the STANDBY button. The alarm will reset for next day.
SNOOZE FUNCTION
If you want to snooze a few more minutes, press the SNOOZE button, it will deactivate the sound for 9
minutes and will shown “SNOOZE” on the LCD Display. To turn off the snooze function, press the
Standby button.
ADJUST VOLUME
1. Press VOL+ button to increase the volume.
2. Press VOL– button to decrease the volume.
RADIO OPERATION
1. Press the STANDBY/FUNCTION button on the unit repeatedly, until the frequency shown on the
display OR, press the STANDBY button on the remote to turn on the unit, then press the FUNCTION
button on the remote until the frequency shown on the display.
How to use the buttons for radio:
•
Manual Tuning
•
Press the SKIP+ / SKIP- button to search for desired frequency.
•
Automatic Tuning
i) Press and hold the SKIP+/SKIP- button until the display frequency starts run.
ii) When a station of sufficient strength has been found Tuning will stop or you can stop the automatic
tuning by pressing SKIP+/SKIP- button.
2. To switch off the radio, press the STANDBY button on the remote once OR press and hold the
STANDBY/FUNCTION button on the unit, until the normal time shown on the display.
PRESET TUNING
1. Select your desired station according to the normal tuning procedure.
2. Press the MEM/PROG button on the unit or MEMORY button on the remote, “P01” will appear and
flash in the LCD, Then use M-UP or M-DN button to change the number where the station will be
stored. (P01 to P20).
3. Store the current frequency by pressing MEM/PROG button on the unit, or MEMORY button on the
remote again when you get the desired number.
4. Repeat the same procedure to set other desired frequencies into Memory No.1 to NO. 20.
Note: The unit can be preset up to 20 stations.
ENG-6
