Instruction Booklet
11
ENGLISH
KHEOS
EN
Always allow a few minutes after switch off to enable the system to return to its rest condition (temperature and
pressure).
During maintenance procedures, do not discard any residues into the environment, but comply with current
disposal regulations.
The cylinder must NEVER be removed unless specifically indicated.
Do not perform any repair or maintenance operations when the unit is running or connected to the mains.
The only maintenance and repair procedures to be performed are the ones indicated in this manual. Operations
performed by inexperience staff will affect the overall safety level of the unit and expose the operator to serious
risks.
3.6 Power supply
The power supply of the unit must be connected in accordance with the instructions of DENSO However, the company will not be
responsible for the connection. The safety of the unit is ensured only when it is correctly connected to a power source that has all
the protection features required by current applicable regulations (differential safety switch and earthing).
• The connection to the mains must be made using the plug provided with the unit, and a reduction used if necessary;
you must first check that the line voltage corresponds to the one indicated on the label on the rear of the unit.
• In the event of damage, you must contact our Technical Service Department.
If the power plug needs to be replaced, contact our Technical Service Department; do not replace the plug
unless you have first obtained written permission by our competent department. Failure to comply with the
above requirement will relieve DENSO of any responsibility for personal injuries or property damage caused by
the power supply.
If using extensions, check that the section of the cable is adequate for its length and that it is positioned so as
to prevent every kind of damage (avoid walking areas and wet areas).
Make sure that the point of connection to the power source has all the protection features required
by the applicable regulations (earthing and differential switch).
4.
Handling and transport
Before moving the unit, check that it is stable (check that the support surface is horizontal).
Before moving the unit, we recommend you remove the parts installed after delivery in order to prevent dama-
ge.
During this phase, you should:
- correctly position all the accessories provided to prevent them from falling or being damaged during transport;
- move slowly and carefully to prevent possible instability;
- keep at a safe distance.
Be especially careful when handling the unit in the workplace. In particular, avoid humps, steps or similar. Lack
of care during transport may affect calibration of the unit.
Summary of Contents for Kheos
Page 2: ...EN ...
