2.2 Push button
The push button on the front left side of the device allows two advanced
functions:
Length
Function
Usage
Two short presses System reset
Use this function if Wi-Drive
becomes unresponsive in any state
Very long press
(>15 secs)
Restore factory defaults If you forgot the administration
password, or you want to restart
configuration from the default
settings.
3 Operation
If your Wi-Drive is installed and fully set up, it will power up when the ignition of
the car is on.
After powering up, it will connect to the internet and you can start using the WiFi
hotspot.
When the ignition of the car goes off, Wi-Drive will power down, and stay in a
low-power standby mode.
4 Troubleshooting
In case Wi-Drive does not work as expected, check the followings:
Problem
Resolution
Cannot connect to
Wi-Drive over
Wi-Fi
•
Check whether Wi-Drive is powered on
•
Check the network settings on your computer
•
Make sure you did try to connect to Wi-Drives WiFi
network and use the correct password
•
Perform a system reset via the push button
•
Restore the factory default settings
Cannot connect to
the internet via
Wi-Drive
•
Ensure that the 3G modem is inserted firmly into the
USB connector
•
Ensure that your GSM Preferences are set up
correctly (contact your network operator if
necessary)
•
Check whether Wi-Drive could establish an internet
connection (on the About tab of the administration
