5
Operation
Installing the Envoi Receiver 2 Module
To install the Envoi Receiver 2, follow these setup steps:
1.
Make sure the power cable is disconnected and
Envoi is powered off.
2.
Remove the two screws on the top right Envoi
Receiver blank plate covering the compartment
using a mini-screwdriver, type 000 (see
figure
1
).
3.
Find the two ribbon cables grouped together
in the panel compartment and remove the clip
holding the cables together (see
figure 2
).
4.
Connect the cable with red, gray, and black wires
to the top of the board on the Envoi Receiver 2
(see
figure 3
).
5.
Connect the smaller cable with the gray wire to
the bottom of the board on the Envoi Receiver 2
(see
figure 4
).
Note:
Make sure not to attach the cables
backwards.
6.
Gently tuck the cables under the board and slide
the Envoi Receiver 2 downward into the panel
(see
figure 5
).
7.
Attach the two screws to the Envoi Receiver 2
panel.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Summary of Contents for Envoi Receiver 2
Page 2: ......
