Denon DRA-CX3, Operating Instructions Manual

Page: 6 / 19

ENGLISH
Connections
Oper
ation
Tr
oubleshooting
Specifications
ENGLISH
Cautions on installation
About the remote control unit
The included remote control unit (RC-1060) can be used to control the
DENON DCD-CX3 Super Audio CD player in addition to the DRA-CX3
(
v
page 4).
Note:
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
q
Remove the remote control
unit’s rear cover.
w
Set two R03/AAA batteries in
the battery compartment in
the indicated direction.
e
Put the rear cover back on.
30°
30°
Approx. 7 m
• Point the remote control unit at the remote sensor when operating
it.
• The remote control unit can be used from a distance of up to about
7 meters, at a horizontal angle of up to 30° with respect to the
sensor.
Inserting the batteries
Operating range of the remote control unit
Cautions on handling
• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
• Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power supply cord from the
power outlet.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
• Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Accessories
q Operating instructions ................................................... ..........1
w Service station list ......................................................... ..........1
e Power supply cord (Cord length: Approx. 1.5 m) .................... 1
r Remote control unit (RC-1060) ................................................ 1
t Dry cell battery (R03/AAA) ....................................................... 2
y AM loop antenna ..................................................................... 1
u FM antenna ............................................................................. 1
r t y u e
Check that the following parts are supplied with the product.
b Note
b b
b
Wall
NOTE:
• The set may function improperly or the remote control unit may
not operate if the remote control sensor is exposed to direct
sunlight, strong artificial light from an inverter type fluorescent
lamp or infrared light.
Getting Started
Get
ting Star
ted
Notes on batteries:
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
(The supplied batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper
direction, following the “
q
” and “
w
” marks in the battery
compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be
in use for long periods.