ENGLISH
Get
ting Star
ted
Oper
ation
Tr
oubleshooting
Specifications
ENGLISH
Connecting the AM loop antenna
Assembling the AM loop antenna
1
4
2
3
1. Insert the antenna wire while
pressing the lever.
2. Release the lever to lock the
antenna wire in place.
a. With the antenna on
top any stable surface.
Remove the vinyl
tie and take out the
connection line.
b. With the antenna
attached to a wall.
Installation hole Mount on wall, etc.
Bend in the reverse
direction.
Connect to the AM
antenna terminals.
Mount
Direction of broadcasting station
AM loop antenna
(Supplied)
Ground
AM outdoor antenna
FM antenna
(Supplied)
An FM antenna can be connected directly.
Connecting the antenna terminals
Connecting a turntable
"6%*0065
(/%
R
L
A
• If connecting the turntable ground wire causes noise, disconnect it.
For instructions on connecting the turntable ground wire, refer to the operating instructions included with
the turntable.
• Set the CARTRIDGE selection switch to “MM” or “MC” according to the cartridge being used.
Turntable
Connecting a CD player
3
-
"6%*0065
R
L
R
L
A
CD player
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an AM outdoor antenna is used, do not
disconnect the AM loop antenna.
• It is not possible to receive AM broadcasts
with good quality if the AM loop antenna is
near something metallic.
NOTE:
• If a turntable is not connected to the PHONO input terminals, do not select PHONO since this can
cause humming and noise, especially if the volume is turned up high.
When not connecting a turntable, leave the included short-circuiting pin plugged in.
• The DRA-CX3’s SIGNAL GND terminal (
) is not a safety ground.
Connections
FM outdoor antenna
7 Ω/ohm coaxial
cable
Black
White
Summary of Contents for DRA-CX3
Page 18: ......
