Denon D-M38S, Service Manual

Page: 21 / 95

21
u
RFRP
"
1 3
"
X X X X
R F R P
(
1
,
3
flashing / XXXX:Adjustment value
)
（
2) Press the
2
button, "4. CD test mode (1)" display reappears.
※ If auto adjustment is not completed, proper values are not displayed.
4.7 Laser current is display
(1) When the
2
button is pressed for over 1 second while the RCD-M38 is in the stop mode(Display of "4. CD test mode
(1)"), the laser turns on and the laser current is measured.
"
1 3
"
S / C : X X m A / Y Y m A
L A S E R C U R R E N T
(
1
,
3
flashing / XX:Stored data(stored in the EEPROM) / YY:Current value
)
• The first current value is measured 3 seconds after the laser turns on.
• The current value is updated every 3 seconds.
• The laser drive current undergoes A/D conversion for calculation. Decimal values are discarded.
（
2) Press the
2
button, "4. CD test mode (1)" display reappears.
※ Stored data is not cleared, initialazation of "3. Cold start mode".
4.7.1 Overwriting the stored data
(1) When the
1
/
3
button is pressed for over 5 seconds while the laser current is displayed, the current value is stored
in the EEPROM (overwriting the stored data).
"
1 3
"
S T O R E D
L A S E R
C U R R E N T
(
1
,
3
flashing )
（ 2) Press the
1
/
3
button, the initial value is stored in the EEPROM
(3) Once rewriting is completed, the display in No.4.7(1) reappears.
※
Rewriting is performed upon shipment from the factory and when the mechanism is replaced.