Denon AVR-X1400H, Owner'S Manual

Page: 168 / 271

5
Select “Start”, then press ENTER.
Audyssey ® Setup can also make the following settings.
0
Amp Assign
The signals output from the SURROUND BACK speaker
terminals can be switched in accordance with your speaker
environment. (“Amp Assign” (
v
p. 175))
0
Channel Select
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of
surround back speakers.
0
Dolby Sp.Setup
Set the distance between the Dolby Atmos Enabled speaker and
the ceiling.
This can be set when “Assign Mode” is set to “Front Dolby” or
“Surround Dolby” in the “Amp Assign” settings. (
v
p. 175)
6
Follow the instructions on the screen display and press
“Next” to proceed further.
7
When the following screen is displayed, select “Begin
Test” and then press ENTER.
Start the measurement of the first position.
.
Select “Begin Test” to Start the Calibration.
NOTE:You will hear a series of loud test tones
starting and stopping during the tests.
Ear Height
Begin Test Back
Audyssey Setup
0
Measurement requires several minutes.
NOTE
0
If “Caution!” is displayed on TV screen:
0
Go to “Error messages” (
v
p. 173). Check any related items, and
perform the necessary procedures.
Contents Connections Playback Settings Tips Appendix
168
Front panel Display Rear panel Remote Index