The Operating Manual for DENON AV Receiver/Amplifier firmware upgrade Page 11 / 18
4.4
Connect the AV Receiver/Amplifier and the PC
1) Connect the AV Receiver / Amplifier and the PC
(refer to 2.1.b).
2) Push [OK] button on the dialog.
4.5
Turn on the AV Receiver /Amplifier
1) Turn on the power switch of the AV Receiver /Amplifier.
2) Confirm the power indicator is green. If the power indicator
is red, Make the power indicator green pushing the
[ON/STANDBY] button.
4.6
Setup the IP address of the AV Receiver / Amplifier
You can see the dialog box like the right picture. This dialog shows the procedure of the network
setting of the AV Receiver / Amplifier.
1) Push the [SYSTEM SETUP] button on the
AV Receiver / Amplifier or the remote
controller.
2) Select “7. Option Setup” and push the [CH
SELECT ENTER] button on the AV
Receiver / Amplifier or the remote
controller.
3) Select “7. Network Setup” and push the
[CH SELECT ENTER] button on the AV
Receiver / Amplifier or the remote
controller.
4) Select“IP Address” and push the [CH SELECT ENTER] button on the AV Receiver / Amplifier
or the remote controller.
5) Select “DHCP” and move to “OFF” using cursol [<] or [>] button.
6) Select “IP Address” using cursol [Down] button on the AV Receiver / Amplifier or the remote
controller.
7) Set the IP Address according to the specified value on the dialog box using [Up], [down], [Left]
and [right] buttons on the AV Receiver / Amplifier or the remote controller.
8) After that, push the [CH SELECT ENTER] button on the AV Receiver / Amplifier or the remote
