1
GUI Menu Map
Set
up
Inf
or
mation
Tr
oubleshooting
ENGLISH
Quick Select Function
With this function, the currently playing input source, input mode,
surround mode, room EQ,
Dynamic EQ
,
Dynamic Volume
settings and volume can be stored in the memory.
1
Set the input source, input mode, surround mode,
room EQ, Dynamic EQ, Dynamic Volume settings
and volume to the conditions you want to store.
2
Press and hold the desired
QUICK SELECT
.
Keep pressing the button until the quick select indicator lights.
Input Source
Volume
Quick Select 1
DVD
–40 dB
Quick Select 2
TV/CBL
–40 dB
Quick Select 3
VCR
–40 dB
[Quick Select Defaults]
1
Connect the HDMI to the AVR-4308 / AVR-3808
with equipment compatible with the HDMI control
function.
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b
Please consult the operating instructions for the connected
equipment to check the settings.
b
Steps 1~3 do not have to be repeated once started.
b
Carryout steps 2 and 3 should any of the equipment be plugged
out.
4
Switch the television input to the HDMI connected to
the AVR-4308 / AVR-3808.
5
Switch the AVR-4308 / AVR-3808 input to the HDMI
input source and check if the picture from the player
is ok.
6
Put the television power on standby and check if the
AVR-4308 / AVR-3808 goes into standby.
If the AVR-4308 / AVR-3808 does not work please check the
following.
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Control” (
v
page 5) set to “ON”?
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI
Control” – “Control Monitor” (
v
page 5) set for the monitor output
connected to television? (AVR-4308 only)
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Power Off Control” (
v
page 5) set to “ON”?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step’s 2 and 3.
•
GUI menu “Source Select” – “(input source)” – “Assign” – “HDMI”
(
v
page 6) setting has changed.
•
There is a change to the connection between the equipment and
the HDMI, or an increase in equipment.
Operations
QUICK SELECT
QUICK SELECT
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
<Illustration : AVR-4308>
Pla
ybac
k
AVR4308ACI-3808ACI_E2A_2nd.indd 12
2008/08/25 10:13:43
