Denon AVR-1705, Operating Instructions Manual

Page: 31 / 111

31
ENGLISH
Recalling preset stations
2 1
2
1
NOTE:
• Please make sure the “AUDIO” position of
the slide switch on the remote control unit.
1
Watching the display, press the SHIFT button to
select the preset memory block.
2
Watching the display, press the PRESET • (+)
or ª (–) button to select the desired preset
channel.
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the
button settings are reset to the default values
(the values set upon shipment from the factory).
2 1, 2
17 INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable
result, the initialization of the microprocessor is required by the following procedure.
1
Switch off the unit using the main unit’s power
switch.
2
Hold the following SPEAKER A button and B
button, and turn the main unit’s power switch.
3
Check that the entire display is flashing with an
interval of about 1 second, and release your
fingers from the 2 buttons and the microprocessor
will be initialized.
16
LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they
were immediately before the power is switched off.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory
storage when the main unit’s power switch is off and with the power supply cord disconnected.