Get
ting Star
ted
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
NOTE
• Insert the AC plugs securely. Incomplete connections could cause noise.
• Only use the AC outlet to plug in audio devices. Do not use them as power supplies for hairdryers or
anything other than audio equipment. In addition, do not connect audio devices such as high electricity
consumption power amplifiers (e.g. POA-A1HD).
Wait until all connections have been completed before connecting the power cord.
To household
power outlet
(AC 230 V, 50 Hz)
Power cord
(included)
Connection to the AC outlet
• These outlets supply power to external audio
devices.
• The power supplied from this outlet turns on and off
together with the set’s power switch.
• Audio equipment with a total power consumption
of 100 W (0.43 A) can be connected.
Connecting the Power Cord
Trigger output jacks
The power of an external device equipped with
a trigger input jack can be turned on and off in
association with operations on the AVP-A1HD. For
details, see GUI menu “Manual Setup” – “Option
Setup” – “Trigger Out 1”, “Trigger Out 2”, “Trigger
Out 3” or “Trigger Out 4” (
v
page 41).
• Output level: 250 mA/12 V
Check the trigger input conditions of the
connected device.
External Controller
• When using in combination with an RF Remote Controller (RC-7000CI, sold separately) and RF Remote
Receiver (RC-7001RCI, sold separately) two-way communication with an RF Remote Controller is possible.
The AVP-A1HD’s status information as well as iPod and Internet audio music files can be browsed
watching the RF Remote Controller’s display. For details, refer to the operating instructions of the
respective devices.
• When used in combination with an RF Remote Controller and RF Remote Receiver, make the settings at
GUI menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (
v
page 42).
• When using the 2-way remote control unit, connect to the Port 1 RS-232C connector.
• If GUI menu “Manual Setup” – “Option Setup” – “2Way Remote”is set to “Used”, you cannot use port 1
of the RS-232C terminal for the external controller.
RS-232C connector
This connector is used for an external controller.
b
If you use an external controller to operate
the unit via the RS-232C terminal, you must
confirm the following beforehand.
q
Turn on the AVP-A1HD’s power.
w
Turn off the AVP-A1HD’s power from the
external controller.
e
AVP-A1HD enters the standby status.
Turning the Power On
(
v
page 56)
Once Connections are Completed
Connections
