20
SP20057_REV1.0
SETTING THE CYLINDER
The Cylinder cassette can be set either in or out of the machine.
To remove the cassette see following page.
To set:
● Slacken 2-off lock nuts (Item 1) [19mm spanner]
● Rotate nut (Item 2) anti-clockwise to bring the
blade towards the cylinder.
● Check the setting using thin paper along the
length of the cylinder.
● Adjust until it cuts across the whole length.
● When set, tighten the lock nut (Item 1)
● Recheck adjustment.
● DO NOT set the cylinder hard to the bottom
blade.
● This will cause excessive wear of both
components and increase power consumption.
HANDLEBAR ADJUSTMENT
The “Handle Bars” are adjustable to achieve the correct working
height for the operator.
To set:
● Slacken off 6-off nuts (Item 1) ¼” turn [17mm
spanner]
● Raise / lower the “Handle Bar” to the desired
position.
● When set, tighten the nuts (Item 1)
C
B
D
A
Item 1
Item 1
Item 2
