11
2. Set curing program
Short press function switch
can select suitable curing
program.
①
Curing Program 1: Full power
②
Curing Program 2: Soft start to full power
③
Curing Program 3: Soft start to half power
3. Set curing timer
Press function switch
to select curing time between
5,10,15,20,25,30,35 and 40 seconds.
When choosing Curing Program 2
and Curing
Program 3
, the cutting time should start from 10 seconds.
4. Start to operate
Press curing switch to start curing program. “Beep” sound will
be heard every 5 seconds. To interrupt a program, just press
curing switch again. When the program is finished, the unit will
turn off the light immediately.
5. Low Battery Sign
When low battery sign
is flashing on the panel, the
battery needs to be charged immediately or connecting the
charger with the handpiece for continuous use.
12
6. Turn off the power
When the unit turns into sleeping mode automatically, it will
shut down all the function except the battery sign, beep sound
sign and curing program sign on LCD panel to save the power.
7. Use Build-in meter
For better curing performance, user should check the light
intensity of LED before use. It is fairly obvious to know the light
intensity just to see how many light indicators become bright
simultaneously.
Inset the light guide to intensity test hole after plug charger
into the outlet of power.
The meter will measure the intensity of LED curing light by
lighting-up the indicators. User can use the reading to adjust the
curing time.
If five indicators become bright simultaneously, it stands for
the intensity is at least1000 Mw/cm2. If only three indicators
become bright simultaneously, it stands for the intensity is a little
lower! In this situation, the user had better charge the unit at
once!
Summary of Contents for DY400-4
Page 1: ......