63
version 1.7
Service Manual Gym
For installation, maintenance, service and guarantee
The posts of the Gym, SportPoint, Basix and StreetWorkout are hot dipped galvanized and after that polyester powder
coated because from the inside rust can leak through threaded holes etc. For parts that have had a hot dipped galva-
nized pre-treatment a 10-year guarantee is applicable. When in this case damage is caused the zinc layer will tempo-
rary protect against rust, but cleaning and touching up is also necessary.
3. A 10-year guarantee is provided on the stainless steel parts. Within this period, no rust should appear at normal
usage. Rust can only occur when there has been contact with steel objects. Damages or deformations can only occur
through improper use. In these situations, the guarantee is declined.
4. A 5-year guarantee is provided on the thermal zinc parts of the floor. Usually, a 10-year guarantee is provided on
thermal zinc, but because it will be walked on frequently, the zinc layer can wear out. Damages from applied force,
blows or scratches is not covered under the guarantee.
5. A 10-year guarantee is provided on the construction of all components. That is, all the welds of the steel parts and
stainless steel parts and the bolt connections. This guarantee is only valid when the device is used for the exercises as
indicated on the instruction pictograms.
6. A 3-year guarantee is provided on the rubber floor parts of the Gym and Professional Sportpoint devices. This only
applies for normal usage of the floor.
In all cases for which this document does not provide an answer or when there is doubt about the cause of damage or
poor functioning, the manufacturer will be consulted via the supplier or directly. The manufacturer's judgment will be
binding.
*This guarantee is not valid for locations less than 5 km from the (ocean) coast and in airport vicinities or industrial
areas with a lot of emissions (C5 category environment). For devices with a 2 layer coating the guarantee will expire,
unless an extra thick coating layer (epoxy-primer of at least 60 to 100 micrometre, and finishing layer from 60 to 80
micrometre) has been selected, the 5-year guarantee term is then applicable.
For devices which are standard hot dipped galvanized the guarantee period is 5 instead of 10 years. Is an extra thick
finish layer selected then the guarantee period will remain 10 years.
**This guarantee is not valid for locations less than 5 km from the coast and in airport vicinities or industrial areas
with a lot of emissions. For this, a guarantee term of 5 years is applicable. In these situations, when Stainless Steel
316 is selected instead of the standard 304, the 10-year guarantee term is then applicable. With both types of materi-
al, discoloration can occur in the environments mentioned above.