62
version 1.7
Service Manual Gym
For installation, maintenance, service and guarantee
GUARANTEE CONDITIONS DENFIT, december 2016
When the Denfit devices were developed, the intention was to create products for public spaces, where user
friendliness and resistance to vandalism are combined as well as possible. The result is a series of high quality, low
maintenance devices, on which a guarantee can be provided with proper use and timely maintenance.
Proper use means that only the exercises indicated on the instruction pictograms are performed. Timely maintenance
relates, in particular, to point 1.
The following guarantee terms apply:
2 year guarantee on the moving parts.
5/10 year guarantee on the powder coating. *
10 year guarantee on the stainless steel parts. **
5 year guarantee on the thermal zinc work.
10 year guarantee on the construction of all parts.
3 year guaranty on the rubber floor parts.
1. A 2-year guarantee is provided on the moving parts, provided that they have been properly maintained. The first
maintenance (see maintenance instructions) must be performed 3 months after first use, thereafter every 6 months.
For devices that are used very intensively or that are installed in a sandy environment, the maintenance frequency
should be higher. When it can be proved that the relevant maintenance was performed, that there is no question of
improper use and the components are truly defective within the guarantee term, the relevant components will be sent
at no charge.
2. Most steel parts come with a standard 2-layer system for outside application: Fitpoint, Gym, Professional SportPoint,
PaceFit and PaceWalk.
This 2-layer system involves:
Pre-treatment: remove grease and oil and then blast clean with sharp-edged blasting
agent up to C SA 2½, maximum roughness profile of 35-45 micrometer.
Base coat: One layer of epoxy primer with an average value of over 60 micrometer (according the process settings pre-
scribed by the supplier).
Finishing coat: One layer of polyester powder coating with a minimum thickness of 60-70 micrometer (according the
process settings prescribed by the supplier).
A 5-year guarantee is provided on the coated parts with a 2 layer coating. Within this period, no rust should appear
from inside out with normal use. Rust can only appear on the outside when the top layers are damaged. This can only
occur through improper use, such as manipulation with a hard object or scratches with a sharp object or damage dur-
ing placement. When this damage is not immediately taken care of, the guarantee expires. At the same time, it is nec-
essary to clean the coated parts. The lifespan of the powder coating is influenced by filth and moisture.
Therefore timely cleaning is essential in order to preserve the lifespan. Each year, the device must be cleaned at least
once.
