1. Mounting The Horn
1.1 - Mounting The Compressor
Find a suitable mounting location on the vehicle that is protected from road debris and
spray from your tires. Universal and Vehicle-Specific Mounting Brackets are available for
purchase separately.
Step One:
Use the M8x16 Bolt (c) and M8 Nut (d) to attach the compressor to the
mounting location.
Note:
The compressor should be mounted so that the cylinder is vertical. There should
be no more than a 25 degree variance from the vertical position.
1.2 - Bolt-On Mounting The Acoustic Unit
Step One:
Use the M6x20 Bolt (e), Vibration Dampener (f) and M6 Nut (g) to attach the
Acoustic Unit (b) to the mounting location.
Note:
The Acoustic Unit can also be mounted using the supplied Zip Ties. Continue to
Section 1.3 for Zip Tie mounting.
DENALIELECTRONICS.COM
90º
115º
65º
-25º
+25º
Maximum Allowable Mounting Angle
Compressor
Acoustic Unit
M8x16
M8 Nut
Example Mounting Bracket
M6x20
Vibration
Dampener
M6 Nut
Example Mounting Bracket
1.3 - Zip Tie Mounting The Acoustic Unit
Step One:
Slide the Zip Tie (i) through the slots in the Acoustic Unit (b).
Step Two:
Tighten the Zip Ties (i) to secure the Acoustic (b) Unit to the vehicle.
1.4 - Connecting The Air Hose
Once you have mounted the Compressor and Acoustic Unit you will need to connect
them using the supplied Air Hose.
Step One:
Route the hose (h) through the vehicle to connect the two units. Be sure to
avoid areas of extreme heat such as the engine head or exhaust. The hose is rated for
175° F.
Step Two:
Trim the hose to the correct length, then you can push each end of the hose
onto the nipples on the compressor and acoustic unit. It is helpful to heat up the ends
of the hose using a heat gun before
Air Hose
Acoustic Unit
Compressor
Zip Tie
Acoustic Unit