4. Mounting The Switch
DENALIELECTRONICS.COM
3. Installing The Harness
Circuit One - Left Aux Light
Circuit Two - Left Aux Light
Trigger Wires
Battery
Light Extensions
DialDim™
Switch
DialDim™
Controller
Circuit Two - Right Aux Light
Circuit One - Right Aux Light
4.1 - Handlebar Mounting
The DialDim™ Switch includes a 7/8” band for mounting to handlebars,
but also can be surface mounted. Follow the steps below for handlebar
mounting, or continue to
Section 4.2
for surface mounting instructions.
Step One:
Place the band around the handlebar.
Step Two:
Use the two M3.5 screws and a 3mm allen key to attach the
switch to the mounting band. Continue tightening the screws until the
switch no longer rotates on the handlebar.
4.2 - Surface Mounting
The DialDim Switch is designed to be surface mounted in two different
orientations, side mounted or rear mounted.
Step One:
Clean and prep the mounting surface and the bottom of the
switch using an alcohol swab. Allow surfaces to fully dry.
Step Two:
Adhere the switch to the mounting surface using double
stick tape. We recommend using 3M VHB tape.
Note:
To ensure a stronger bond use a heat gun to warm the tape
before applying to the surface.
3.1 - Connecting The Trigger Wires
The DialDim Controller features input trigger wires, connect them to each
corresponding circuit to unlock intelligent flash features. The simplest way to
identify each circuit is to use a test light to probe connectors/wires while
cycling the corresponding switch on the vehicle.
Required Input:
White Switched Power Trigger Wire -
This trigger wire signals the controller
to power ON and OFF with the vehicle’s ignition.
Optional Inputs:
Blue High Beam Trigger Wire -
This trigger wire enables “High/Low Sync”;
the auxiliary lights will automatically switch between your selected dim setting
to full intensity with the factory high beam switch.
Green Horn Trigger Wire -
This trigger wire enables “Strobe with Horn”; the
auxiliary lights on both circuits will strobe at 4Hz when you sound your horn.
Orange & Yellow Turn Signal Trigger Wires -
These trigger wires enable
“Cancel with Turn Signals” & “Flash as Turn Signal”; the auxiliary lights on
circuit one will cancel with the vehicle’s turn signals, the auxiliary lights on
circuit two will flash with the vehicle’s turn signals.
3.1 - Connecting To The Battery
Step One:
Remove the fuse from the fuse holder.
Step Two:
Access the vehicle’s battery and disconnect the negative (-)
and positive (+) terminals.
Step Three:
Connect the DENALI wiring harness to the battery via the
ring terminals, be sure the red wire lead with the fuse holder in-line
goes to the positive (+) terminal of the battery.
Step Four:
Re-install the fuse into the fuse holder.
Note:
When possible, place the fuse holder in an easily accessible
location for convenient service in the event of a blown fuse.
Side Mounting
Rear Mounting
