Rev. A, February 2021
Page 4
Pro-Tacker Operator’s Manual
5.1
Unpacking and Preparation
a.
Before opening the Pro-Tackers box and unpacking the system, inspect the outside of
the box thoroughly for any signs of mishandling or damage during shipping. Report
any damage to the shipping carrier immediately and do not proceed with unpacking.
Since the shipment is made FOB factory, you should consult your administration
concerning claims for shipping damage. Please notify DEMTECH Services, Inc.
immediately in writing of any shipping damage.
b.
Open the Pro-Tackers box and thoroughly inspect inside the container and equipment
thoroughly for any signs of mishandling or damage during shipping. Report any
damage to the shipping carrier immediately and do not proceed with unpacking. Since
the shipment is made FOB factory, you should consult your administration concerning
claims for shipping damage. Please notify DEMTECH Services, Inc. immediately in
writing of any shipping damage.
5.2
Operation and Features
a.
The Pro-Tacker provides the user with an easy-to-use simple system of powering on
and controlling their Welders output temperature. Plug the Pro-Tacker into a stable
120V (P/N
PRT-75005, PRT-75000
) OR 220v (P/N
PRT-75010
) outlet utilizing the
provided power cord (
Item 3, Figure 5.1
), and simply flip the power switch to the ‘I’
position (
Item #2, Figure 5.1
).
b.
Once the Pro-Tacker is plugged in, turn the red potentiometer knob to adjust the output
temperature, (
Item #1, Figure 5.1
).
c.
Whenever the Pro-Tacker is not in use for an extended period of time or user is done
using tool, cool-down the Pro-tacker as follows:
1.
Turn the temperature all the way down by turning the red knob (
Item #1, Figure
5.1)
all the way counter-clockwise. Allow 2-5 minutes for heating elements and
nozzle to reach a safe temperature.
2.
Flip power switch to “O” position.
