15
TECHNICAL SPECIFICATIONS
Energy storage capacity is 66 milliFarad.
Stable operation with ergonomic gun
It can weld 5 to 10 studs per minute. (This number depends on the stud size.)
Voltage or power can be adjusted digitally according to the bodywork thickness to
be pulled and the size of the stud to be welded.
Supply Voltage
U
1N
1 Faz, 220 V 50 Hz.
Open Curcuit Voltage
U
20
3,0 V
Supply Fuse
C Tipi
1x16 A
Maximum Input Power
S
max
0.8 kVA
Maximum Output Current
I
2CC
7.5 kA
Insulation Class
H
Protection Class
IP 21
Dimensions (w/l/h)
cm
47 x 50 x 102
Weight
kg
40
OPERATION
Single phase power supply 220V 50Hz.
For optimum operation, do not use any extension cords.
If needed use min. 3x2,50 mm
2
cables.
Connect the input cable of the machine to a grounded outlet.
Choose the current setting according to the bodywork you will work on.
Make sure that the part of the workpiece to be applied is not painted, oily or too
dusty to prevent conductivity.
Hold the dent puller gun perpendicular to the workpiece.
Depending on the size of the dent, you may need to repeat the pulling repeatedly. To
get a good result, this process should be repeated step by step.
If the puller tip or working body area gets hot, wait until it cools down.
16
Make sure the ground plate is clamped firmly in place on the
inside of a clean metal surface as near as possible to the weld
location.
Do not connect it to a different part of the car body (example: Do
not connect it on the door when working on the wing).
TROUBLESHOOTING
Symptoms
Causes
Remedies
Tip does not stick to
panel after a while of
useage.
Tip of the spot gun is
hot
Weld location is hot
Wait a while for the tip and the weld
location to cool down.
Use a wet towel to cool down the
heated parts.
The device's leds are
not on.
Device does not
operate.
Damaged input cable
There is no mains
electricity in the socket.
Make sure there is electricity to which
the device is connected.
If the problem persists, contact service.
Device output power is
low.
Output cables or
connections are
damaged.
Check the output cables and
connections. If damaged, fix the
connections.
Device does not trigger.
Problem on dent puller
switch or its connection
Try operating the device in automatic
mode.
If the problem is only in manual mode,
check the gun connection and contact
the service.
Mains fuse trips
Insufficient input fuse
Use a
C-type fuse
with at least
16 A
in
the socket.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and
labour).
Our warranty coverage is limited to the manufacturing defects of our machines. The use of
machines other than their intended purpose, failure to comply with the conditions in the user
manual, making incorrect network connections, not using original accessories, maintenance
and repair of the machine other than the authorized service within the warranty period, and
malfunctions that may occur as a result of natural disasters are not covered by the warranty. In
addition, the accessories supplied with the machine are limited to the warranty of the
manufacturers of these goods.
• If the goods fail within the warranty period, the time spent in repair is added to the warranty
period. The repair time of the goods is a maximum of 20 working days.
