DEMAG DC-Com 1, Operating Instructions Manual

Page: 79 / 116

Fig. 48
1. Remove guide plate (7);
2. Remove retaining ring (8) using ring pliers; either use straight or offset pliers (access through the opening in
the gearbox housing on the side of the motor or from the service enclosure);
DC-Com 1 to 5: In the area power supply insert;
DC Com 10: Fold cover (9) of the opening in the gearbox housing to the side.
3. Remove chain guide (10) with the sprocket from the output shaft; to do this, slide the complete assembly in
the direction of the motor until the sprocket is free; the worn chain can then be removed from the service
enclosure.
Proceed in reverse order to install the new chain set.
Pay attention to the following points:
214
80
2 44/291
113
79