LED STRIP KIT
FITTING INSTRUCTIONS
(SINGLE COLOUR - IP65)
DEL0670g/Feb_2017/issue_1 page 2 of 2
www.delucelighting.com
Cutting the LED Strip Light
The LED Strip can be cut at 50mm intervals and can be relinked using either a connect clip, a double ended connector cable c/w
150mm of cable, single ended connector clip c/w 150mm of cable or by soldering a cable between the LED Strip Light's copper
connectors (all connectors supplied with kit).
Cut the LED strip at the designated cutting line, marked with a
✂
its is recommended that a suitable craft knife is used to cut the
LED Strip Light.
Once cut; use the craft knife to remove the outer plastic sleeve, as close to the nearest LED light, near the cut as possible to expose
the copper connectors ( & – ).
Slide a piece of heat shrink over the end of the LED strip - open a flap on a connector clip / connector cable - slide the now cleaned
end piece into one side of a connector clip / connector cable and then using a soldering iron,
YOU MUST
solder the connector
clip's terminals to the LED strips copper connectors in turn.
Or solder a piece of cable between the LED Strip Light's copper connectors as follows :
RED
(Po to Po)
BLACK
(Negative – to Negative –)
Using the supplied glue, glue down the flap(s) of the connector clip; then slide the heat shrink sleeve over the now finished connection
(using a Hair Dryer) heat the heat shrink until it contracts sufficiently.
Over the tailing end of the LED strip light fit an End Cap ( apply a small amount of glue to the inside of the end cap and then slide
over the tailing end area ).
Then follow the steps 1 - 7 for installation.
LED Strip Accessories
Ref no.
Qty
Description
LEDSTRIPDRI40*
1
LED driver - Output 40W
LEDSTRIPACC003
POLARITIES MUST BE MAINTAINED
LEDSTRIPACC002
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
LEAVE A COPY FOR THE USER/MAINTENANCE ENGINEER FOR FUTURE REFERENCE
We recommend this fitting is installed by a qualified Electrician.
1m ADD-ON LED STRIPS
3m ADD-ON LED STRIPS
*Note:
Runs up to 8m static only
Product Code
Description
LEDSTRIPACC001
10mm Single colour strip connector c/w 15cm of wire
(5pcs)
LEDSTRIPACC002
10mm Single colour strip connector (5pcs)
LEDSTRIPACC003
10mm Single colour strip link c/w 15cm of wire -
connector at each end (5pcs)
Product Code
LED Colour
Length
No. of LED’s
LEDSTRIPACC/W/1
Cool White
1M
60
LEDSTRIPACC/WW/1
Warm White
1M
60
LEDSTRIPACC/R/1
Red
1M
60
LEDSTRIPACC/G/1
Green
1M
60
LEDSTRIPACC/B/1
Blue
1M
60
Product Code
LED Colour
Length
No. of LED’s
LEDSTRIPACC/W/3
Cool White
3M
180
LEDSTRIPACC/WW/3
Warm White
3M
180
LEDSTRIPACC/R/3
Red
3M
180
LEDSTRIPACC/G/3
Green
3M
180
LEDSTRIPACC/B/3
Blue
3M
180
Product Code
Description
LEDSTRIPACC004
10mm RGB colour strip connector c/w 15cm of wire
(5pcs)
LEDSTRIPACC005
10mm RGB colour strip connector (5pcs)
LEDSTRIPACC006
10mm RGB colour strip link c/w 15cm of wire -
connector at each end (5pcs)
