Delton DVR, Simplified Manual

Page: 14 / 26

Page 14/25
Move cursor to “Sensitivity”. Five options (level 1-5) are available, lower<low<normal<high<higher. You can customize
the settings. If the sensitivity is low, the motion detection alarm will be activated only when the change of scene is
obvious; if the sensitivity is high, the motion detection alarm will be activated when the scene changes slightly.
Step Step Step Step 4: 4: 4: 4: Set Set Set Set motion motion motion motion detection detection detection detection area area area area
The whole image is divided into 48 (6×8) panes. User can select two neighbor pans or independent pan, and the available
option is 48 panes, that mean 48 detection zones. Grey pane indicate that this zone is not under detection; red pans
indicate that these areas are selected; Press [↑]
, [
↓]
, [
←]
,
and
[
→] to move cursor and select area. If the color changes
at selected areas, motion detection will be triggered. If the color changes at areas that are not selected, motion detection
won’t be triggered. As shown in the figure below: motion detection will be triggered in area A (red) instead of area B
(grey). After selection, press “0” to save and exit.
Step
Step Step
Step 5
5 5
5:::: Motion
Motion Motion
Motion Detection
Detection Detection
Detection Time
Time Time
Time
It is just used in normal motion detection, refers to the time after motion detection while recording still last. It is not set
too long, usually about 30s
Step
Step Step
Step 6:
6: 6:
6: Save
Save Save
Save setting
setting setting
setting